Table of Contents
Advertisement
Operation of Test Print
Density Check
Check the density value according to the items to be checked shown below.
Item
Category
Number
Check the display window on the operation panel.
(11) After printing the QC pattern, the calibration icon and message are not displayed on the DRY-
Density
(12) After printing the QC pattern, "NG" is not displayed in "1" to "4" of the "QC results" in the QC
Table 1
Item Number
Step 1 density
Step 2 density
Step 3 density
Step 4 density
The method of determining the deviation of the density from the
reference varies depending on the film type.
The density lattitude of M (mammography) media is narrower. (See
Table 1.)
PRO 873 operation panel
window on the DRYPRO 873 operation panel, but the correct density value (two to three digits)
is displayed
Item to Be Checked for Film Types B and C
Within 0.05 of the initial value
Within 0.2 of the initial value
Within 0.2 of the initial value
Within 0.2 of the initial value
"3.6.5 QC" (page 58)
Item to be Checked
Item to Be Checked for Film Type M
Within 0.03 of the initial value
Within 0.1 of the initial value
Within 0.1 of the initial value
Within 0.2 of the initial value
106
Advertisement
Table of Contents
