Sharp Notevision PG-C20XE Operation Manual page 18

Basic Operations
3
4
Projector
ON/OFF
LAMP
POWER
TEMP.
KEYSTONE
AUTO SYNC
INPUT
BACK ENTER MENU
EXAMPLE
5
INPUT 1
(RGB) Mode
d
INPUT 3
(VIDEO) Mode
6
7
8
E-17
Remote control
8
7
5
6
INPUT 1
(COMPONENT) Mode
g
f
INPUT2
(S-VIDEO) Mode
s
3 Slide the ZOOM knob. The image can be adjusted
to the desired size within the zoom range.
4 Rotate the FOCUS ring until the image on the
screen becomes clear.
5 Press INPUT to select the desired input mode.
Press INPUT again to change the mode.
• When the selected input signal is being received, "Adjusting
The Image" will be displayed.
• When no signal is being received, "NO SIGNAL" will be
displayed. When a signal that the projector is not preset to
receive is being received, "NOT REG." will be displayed.
6 Press VOLUME on the remote control to adjust
the volume.
7 Press AV MUTE on the remote control to
temporarily turn off the picture and the sound.
Press AV MUTE again to turn the picture and the
sound back on.
8 Press ON/OFF on the projector or POWER on the
remote control for over one second.
Press ON/OFF or POWER again while the
message is displayed.
• If you accidentally pressed ON/OFF or POWER and do not
want to turn off the power, wait until the power off screen
disappears.
• When ON/OFF or POWER is pressed twice, the POWER
indicator will light up red and the cooling fan will run for
about 90 seconds. The projector will then enter standby
mode.
• Wait until the cooling fan stops before disconnecting the
power cord.
• The power can be turned on again by pressing ON/OFF or
POWER. When the power is turned on, the POWER indicator
and the LAMP REPLACEMENT indicator light green.
• The POWER indicator flashes if the right side filter cover is
not securely installed.