Electrical System; Battery; Pressure System; Tyres / Tyre / Tire Pressure - Ingersoll-Rand P600WIR Operating & Maintenance Manual

Operating & Maintenance Manual

Electrical System

Always
maintenance or service.
Inspect the safety shutdown system switches and the instrument panel relay contacts for
evidence of arcing and pitting. Clean where necessary.
Check the mechanical action of the components.
Check the security of electrical terminals on the switches and relays i.e. nuts or screws loose,
which may cause local hot spot oxidation.
Inspect the components and wiring for signs of overheating i.e. discolouration, charring of
cables, deformation of parts, acrid smells and blistered paint.

Battery

Keep the battery terminals and cable clamps clean and lightly coated with petroleum jelly to
prevent corrosion.
The retaining clamp should be kept tight enough to prevent the battery from moving.

Pressure System

At 500 hour intervals it is necessary to inspect the external surfaces of the system (from the
airend through to the discharge valve(s)) including hoses, tubes, tube fittings and the
separator tank, for visible signs of impact damage, excessive corrosion, abrasion, tightness
and chafing. Any suspect parts should be replaced before the machine is put back into service.

Tyres / Tyre / Tire Pressure

See the GENERAL INFORMATION section of this manual.

Running Gear / Wheels

Check the wheel nut torque 20 miles (30 kilometres) after refitting the wheels. Refer to the
TORQUE SETTING TABLE later in this section.
Lifting jacks should only be used under the axle.
The bolts securing the running gear to the chassis should be checked periodically for tightness
(refer to the SERVICE/MAINTENANCE CHART for frequency) and re-tightened where
necessary. Refer to the TORQUE SETTING TABLE later in this section.
104
WARNING
!
disconnect the battery cables before performing
Maintenance
any
22442594