Adam Equipment HIGHLAND Series Manual page 31

This product has been manufactured in accordance with the harmonised European standards, following the
provisions of the below stated directives:
2004/108/EC, Electro Magnetic Compatibility
Directive
2006/95/EC, Low Voltage Directive
2011/65/EC, RoHS, on the Restriction of the
use of certain hazardous substances in
electrical and electronic equipment (recast)
2009/23/EC Non Automatic Weighing
Equipment Directive
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. The equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
Shielded interconnect cables must be employed with this equipment to insure compliance with the pertinent
RF emission limits governing this device.
Changes or modifications not expressly approved by Adam Equipment could void the user's authority to
operate the equipment.
DO NOT DISPOSE OF IN GENERAL WASTE
Any Electrical or Electronic Equipment (EEE) component or assembly of parts intended to be incorporated
into EEE devices as defined by European Directive 2012/19/EU must be recycled or disposed of using
techniques that do not introduce hazardous substances harmful to our health or the environment as listed in
Directive 2011/65/EC or amending legislation.
Battery disposal must be performed according to local laws and restrictions.et to impose targets for
recycling
.
© Adam Equipment Company 2014
Manufacturer's Declaration of Conformity
Adam Equipment Co. Ltd.
Maidstone Road, Kingston
Milton Keynes, MK10 0BD
United Kingdom
www.adamequipment.com
Standard EN61326-1:2013, Electrical Equipment for
Measurement, Control and Laboratory Use – EMC
requirements – Part 1: general requirements.
Standard EN61010-1:2010, Safety requirements for
measurement, control and laboratory use equipment
– Part 1: General requirements.
Restricted substances referred to in Article 4(1) and
maximum concentration values tolerated by weight in
homogeneous materials do not exceed prescribed
limits.
Standard EN 45501:1992, AC:1993 (applies only to
certified non-automatic weighing instruments)
FCC COMPLIANCE
WEEE COMPLIANCE
29
Sealed Lead Acid Battery
Remove and recycle
9520revF-Jun14