Safety Instructions - Eneo HDC-1004M1080 Installation And Operating Manual

Installation and Operating Manual
1/3" HD-SDI Board Camera in Housing
with 3.7mm Lens
HDC-1004M1080

1. Safety Instructions

• Read these safety instructions and the operation manual first before you install
and commission the camera.
• Keep the manual in a safe place for later reference.
• P rotect your camera from contamination with water and humidity to prevent it
from permanent damage. Never switch the camera on when it gets wet.
Have it checked at an authorized service center in this case.
• Never operate the camera outside of the specifications as this may prevent the
camera functioning.
• Do not operate the cameras beyond their specified temperature, humidity or
power ratings. Operate the camera only at a temperature range of -10°C to +50°C
and at a humidity of max. 90%.
• To disconnect the power cord of the unit, pull it out by the plug.
Never pull the cord itself.
• P ay attention when laying the connection cable and observe that the cable is not
subject to heavy loads, kinks, or damage and no moisture can get in.
• The warranty becomes void if repairs are undertaken by unauthorized persons.
Do not open the camera housing.
• Never point the camera towards the sun with the aperture open.
This can destroy the sensor.
• Installation, maintenance and repair have to be carried out only by authorized
service centers. Before opening the cover disconnect the unit from mains input.
• The fitter is responsible for the system of protection being followed in accor-
dance with the technical data, e.g. by sealing of the cable outlet with silicone.
• Contact your local dealer in case of malfunction.
• Only use original parts and original accessories from Videor E. Hartig GmbH.
• Do not use strong or abrasive detergents when cleaning the dome.
Use a dry cloth to clean the dome surface.
In case the dirt is hard to remove, use a mild detergent and wipe gently.
• During assembly, care must be taken to ensure that existing seals are
correctly inserted and are not displaced as a result of assembly.
You must not continue to use damaged seals.
NOTE: This is a class A digital device. This digital device can cause harmful
interference in a residential area; in this case the user may be required
to take appropriate corrective action at his/her own expense.
2. General
Main Features
• 1/3" 2.1 megapixels Progressive Scan CMOS sensor
• Resolution max. 1920 x 1080 (HD 1080p)
• 1.5G HD-SDI video transmission via coax cable
• WDR (Wide Dynamic Range)
• Integral motion detection
• RS-485 Communication (Pelco D)
• Digital zoom (0x - 20x)
• Privacy zones
• Supply voltage: 12VDC
• Compact board size (38x38mm)
• OSD control joystick
Parts supplied
Mounting bracket, screw set, connection cable set, manual
CAUTION !
• When you connect service video output cable, WDR function does not work.
• Service video output looks the angle of view narrower than HD-SDI output.
3. Mounting
CAUTION !
Please start installing in the order shown.
4. Connection
OSD Control joystick
Service video connector
HD-SDI
Power / RS 485
Tapping screw:
∅ 3 x 8
Mounting
bracket
Machine screw:
M2 x 2.5
Camera
Handheld monitor
SDI
RECEIVER
HD-SDI In DISPLAY
DEVICE
RS 485
Power jack (12VDC)