Optional Feature Parameters; Nprintf - Cisco ATA 186 Administrator's Manual
Cisco analog telephone adaptor administrator's guide
Hide thumbs
Also See for ATA 186:
- Administrator's manual (218 pages) ,
- Installation and configuration manual (13 pages) ,
- User manual (12 pages)
Table of Contents
Advertisement
Chapter 5
Parameters and Defaults
•
•
Value Type
Bitmap
Default
0x0000002b
Voice Configuration Menu Access Code
324
Related Parameter
OpFlags, page 5-33
Optional Feature Parameters
This section includes the parameters used to configure various timeout values and call-progress tones:
•
•
•
•
•
•
NPrintf
Description
Use this parameter to specify the IP address and port of a host to which all Cisco ATA debug messages
are sent. The program prserv.exe, which comes bundled with the Cisco ATA software, is needed to
capture the debug information.
Syntax
<HOST_IP>,<HOST_PORT>
Example
If the program prserv.exe is running on a host with IP address 192.168.2.170 and listening port 9001, set
NPrintf to 192.168.2.170.9001. This causes the Cisco ATA to send all debug traces to that IP address.
Value Type
Extended IP address
Default
0
OL-4008-01
Bits 18-29—User-specified 802.1Q VLAN ID.
Bits 30-31—Reserved.
NPrintf, page 5-35
RingOnOffTime, page 5-36
IPDialPlan, page 5-36
DialPlan, page 5-37
Call-Progress Tone Parameters, page 5-41
CallCmd, page 5-46
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (H.323)
Optional Feature Parameters
5-35
Advertisement
Table of Contents
