Basic Configuration Steps In A Non-Tftp Server Environment - Cisco ATA 186 Administrator's Manual

Steps Needed to Configure the Cisco ATA
Table 3-3 Basic Steps to Configure the Cisco ATA in a TFTP Environment (continued)
Action
Configure the method with which the Cisco ATA will locate the
6.
TFTP server at boot up time.
Power up the Cisco ATA.
7.
If you make configuration changes to the Cisco ATA or upgrade
8.
the signaling image on the TFTP server, you can refresh the
Cisco ATA so that these changes take effect immediately.
Otherwise, these changes will take effect when the specified
interval (CfgInterval parameter value) for the TFTP query
expires.

Basic Configuration Steps in a Non-TFTP Server Environment

Table 3-4
Table 3-4 Basic Steps to Configure the Cisco ATA Without Using the TFTP Server Method
Action
Download the desired Cisco ATA release software zip file from the Cisco web site:
1.
If you are a registered CCO user. go to the following URL:
a.
http://www.cisco.com/cgi-bin/tablebuild.pl/ata186
Download the zip file that contains the software for the applicable release and signaling
b.
image you are using. The contents of each file are described next to the file name.
Extract the files to the desired location on your PC.
c.
The file that contains the protocol signaling image has an extension of .zup.
Note
Manually upgrade the Cisco ATA to the correct signaling image.
2.
Configure the Cisco ATA by using either one of the manual-configuration methods.
3.
Power up the Cisco ATA.
4.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (H.323)
3-6
shows the basic steps for configuring the Cisco ATA without using the TFTP server method.
Chapter 3 Configuring the Cisco ATA for H.323
Reference
Configuring the Cisco ATA to Obtain its
Configuration File from the TFTP Server, page 3-12
Refreshing or Resetting the Cisco ATA, page 3-20
Reference
Upgrading the Signaling
Image Manually, page 8-2
Voice Configuration
•
Menu, page 3-15
Cisco ATA Web
•
Configuration Page,
page 3-18
OL-4008-01