Sigtimer - Cisco ATA 186 Administrator's Manual

Operating Parameters
•
•
•
Value Type
Bitmap
Default
0xB8
Voice Configuration Menu Access Code
255

SigTimer

Description
This parameter controls various timeout values.
parameter.
Value Type
Bitmap
Default
0x01418564
Voice Configuration Menu Access Code
318
Table 5-5 SigTimer Parameter Bit Definitions
Bit Number Definition
0-7 Call waiting period—The period between each burst of call-waiting tone.
Range: 0 to 255 in 0.1 seconds
Default: 100 (0x64=100 seconds)
8-13 Reorder delay—The delay in playing the reorder (fast busy) tone after the far-end caller hangs up.
Range: 0 to 62 in seconds
Default—5 (seconds)
63—Never play the reorder tone.
14-19 Ring timeout—When a call is not answered, this is the amount of time after which Cisco ATA rejects the
incoming call.
Range—0 to 63 in 10 seconds
Default—6 (60 seconds)
0—Never times out
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (H.323)
5-32
Bit 3: Throughput bit—1=request high throughput
Bit 4: Delay bit—1=request low delay
Bits 5-7: Specify datagram precedence. Values range from 0 (normal precedence) to 7 (network
control).
Chapter 5
Table 5-5 on page 5-32 contains bit definitions of this
Parameters and Defaults
OL-4008-01