Cisco ATA 186 Administrator's Manual page 148

Debugging the Cisco ATA 186/188 Fax Services
Using rtpcatch to Analyze Common Causes of Failure
The following examples show the rtpcatch output of failed fax sessions. <3.200> is ATA; <2.53> is a
Cisco gateway.
Example 7-6
---------- FAX Summary 1 ----------
[
[
Analysis
•
•
Possible Causes for Failure
•
•
Example 7-7
---------- FAX Summary 1 ----------
[
[
[ 1820]<2.53=>3.200> NSE PT
[ 1966]<2.53=>3.200> NSE PT
Analysis
•
•
•
Possible Cause for Failure
•
Example 7-8
---------- FAX Summary 1 ----------
[
[
[ 106]<3.200=>2.53> Codec G711u/D
[ 107]<3.200=>2.53> NSE PT 100, EVT 192: Up-Speed, CED tone Detected
[ 1436]<3.200=>2.53> NSE PT 100, EVT 192: Up-Speed, CED tone Detected
Analysis
•
•
•
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (H.323)
7-18
Cisco ATA Configuration Failure
37]<2.53=>3.200> Codec G723
39]<3.200=>2.53> Codec G723
<2.53> is the originating gateway and <3.200> is the terminating Cisco ATA.
The Cisco ATA and the <2.53> gateway use G.723 codec.
The Cisco ATA is not configured with fax mode or fax pass-through mode.
If the Cisco ATA is the gateway for a fax sender, the remote gateway is not configured with fax
pass-through mode.
Fax Mode Failure
37]<2.53=>3.200> Codec G711
39]<3.200=>2.53> Codec G711
<2.53> is the originating gateway and <3.200> is the terminating Cisco ATA.
The Cisco ATA and the <2.53> gateway begin with G.711 codec.
The <2.53> gateway sends Cisco fax relay event packets.
Cisco fax relay option is not disabled on the gateway.
Fax Pass-through Mode Failure
2]<2.53=>3.200> Codec G723
4]<3.200=>2.53> Codec G723
<2.53> is the originating gateway, and <3.200> is the terminating Cisco ATA.
The Cisco ATA upspeeds to G.711µ-law and sends G.711 upspeed NSE signaling packets.
The <2.53> gateway does not respond to the NSE signaling packets.
96, Cisco Fax Relay
96, Cisco Fax Relay
Chapter 7 Configuring and Debugging Fax Services
OL-4008-01