Making A Conference Call In Sweden; Call Waiting In The United States; Call Waiting In Sweden; Calling Line Identification Presentation - Cisco ATA 186 Administrator's Manual

Appendix A Using H.323 Supplementary Services

Making a Conference Call in Sweden

Procedure
Dial the first number.
Step 1
When the person you called answers, press the flash or receiver button on the telephone handset. This
Step 2
will put the first person you called on hold and a dial tone will sound.
Dial the second person and speak normally when that person answers.
Step 3
Perform a hookflash, then press 2 on your telephone keypad to return to the first person. You can
Step 4
continue to switch back and forth between the two callers.
To conference with both callers at the same time, perform a hookflash, then press 3 on the telephone
Step 5
keypad. Once you conference all three callers, the only way to drop a caller is for that caller to hang up.
(Optional) To conference in additional callers, the last person called with a Cisco ATA can call an
Step 6
additional person, that new person can call someone else, and so on. This is known as "daisy-chaining."

Call Waiting in the United States

If someone calls you while you are speaking on the telephone, you can answer by performing a hook
flash. You cannot conference in all three callers, but the first person you called could call someone else
and daisy-chain them into the conference.
When the Cisco ATA is configured to use Call Waiting by default, press *70 on your telephone keypad
to disable Call Waiting for the duration of the next call.

Call Waiting in Sweden

If someone calls you while you are speaking on the telephone, you can answer by performing a hookflash
then pressing 2 on your telephone keypad, or you can conference them with the person to whom you are
already speaking by performing a hookflash then pressing 3. You can also perform a hookflash then press
3 later during the call to create a conference call.
Performing a hookflash then pressing 1 hangs up the first caller and answers the second call. If there is
no answer after one minute, the caller receives three beeps and a busy signal.
To enable call waiting for Sweden, press *43#. When the Cisco ATA is configured to use Call Waiting
by default, press #43# to disable Call Waiting for the duration of the next call.

Calling Line Identification Presentation

Calling Line Identification Presentation (CLIP) shows your identity to callers with Caller ID.
Press *82 on your telephone keypad to activate CLIP.
OL-4008-01
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide H.323
Common Supplementary Services
A-3