Start-Up; Switching On The Device; Monitoring Power Supply; Network Connection - Mennekes Amtron Xtra E Installation Manual

6. Start-up

6.1

Switching on the device

T
T
DANGER
Electric shock hazard when devices are damaged
Use of a damaged device may result in electric shock.
f Do not use the device if it is damaged.
f Mark the damaged device to ensure that no one contin-
ues using it.
f Have a qualified electrician rectify the damage immedi-
ately.
f Have an electrician take the device out of service if
necessary.
Precondition:
„ Device is installed correctly.
„ Device is in a proper condition.
f Switch on the RCD and MCB.
f Switch on the power supply and check.
Î "6.2 Monitoring power supply"
LED on the power supply is on.
9
9 The "Ready for operation" LED on the LED info field
lights up.

6.2 Monitoring power supply

The device is monitored by a phase sequence relay. It
checks the three phases (L1, L2, L3) and the neutral con-
ductor (N) of the power supply for correct phase sequence,
phase failure or undervoltage.
Operating status display
L1 Three phases, clockwise field of rotation:
L2
f Using terminals L1, L2, L3, N, PE.
L3
f Setting relay potentiometer to 3.
1 3
9 The green LED is lit.
N X
X 16
15 18
L1
Three phases, anti-clockwise field of rota-
tion:
L2
L3
f Using terminals L1, L2, L3, N, PE.
f Setting relay potentiometer to 3.
1 3
The green LED is flashing.
9
N X
X 16
15 18
L1 One phase:
L2
f Using terminals L1, N, PE.
L3
f Setting relay potentiometer to 1.
1 3
The green LED is lit.
9
N X
X 16
15 18
The potentiometer is only evaluated once after applying
the supply voltage.

6.3 Network connection

If the network connection is established, the device can be
configured and used. Functions and modes are configured
with an Internet browser via the service interface of the
device. The device can be operated with a mobile terminal
via the MENNEKES Charge APP.
EN
17