Table of Contents
Advertisement
4. Maintenance
4. Remove the filter cover.
GUID-27F56ED7-221E-4F71-9809-6FD5F44DEC77
1. Filter
2. Equalizing element
3. Filter cover
Use 27 mm wrench.
5. Pull out the filter parts.
6. Fit the new filter elements.
7. Fit the filter cover.
The tightening torque is 20-25 Nm.
8. Close the steps.
Fasten the steps with the two fastening screws.
4.7.5.8
Checking the front wheel toe-in
Check the front wheel toe-in periodically.
1. Make a vertical mark on the rear edge of both front tyres in the middle of the
tread in level with the hubs.
2. Measure the distance between the marks.
3. Roll the tractor forwards so that the marks again come in level with the hubs,
this time at the front edge.
4. Measure the distance between the marks again.
The measurement must be 0-2 mm larger at the rear edge.
5. Adjust the toe-in if necessary.
1
2
3
- 412 -
Advertisement
Table of Contents
