Crown CT11012 Original Instructions Manual page 30

Parallel milling
Using the auxiliary guide (see fig. 20)
You can fix a wood board on the workpiece with the
clamping device and use it as an auxiliary guide� Perform
the milling operation by moving the power tool along this
guide and pressing the even side surface of base plate 4
to the side surface of the wood board (see fig. 20).
Using the parallel guide (see fig. 21)
Parallel guide 26 enables milling along the straight line
side surface of the workpiece�
• Install and adjust parallel guide 26 as described
above�
• Perform the milling operation by pressing paral-
lel guide 26 to the side surface of the workpiece (see
fig. 21).
Copy milling (see fig. 22)
Guide bushing 24 enables template milling (including
curved template)�
• Install guide bushing 24 as described above�
• Perform the milling operation by pressing guide
bushing 24 to the side surface of the template (see
fig. 22).
Note: the
not be less than 8 mm. Additionally,
when making a template, please note
that the router bit follows the template
contour with a certain offset (distance "b" in fig-
ure 22).
Power tool maintenance / preventive
measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
The manufacturer reserves the possibility to introduce changes.
template thickness
Cleaning the dust extraction groove (see fig. 23-24)
• Unscrew screws 32 and remove cover 33 as shown
in figures 23-24.
• Clean the groove with a soft brush�
• Install cover 33 and screw in screws 32�
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� Regularly
flush the power tool with compressed air thought the
ventilation slots 6�
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.crown-tools.com�
Transportation of the power tools
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
must
Environmental protection
Recycle raw materials instead of dispos-
ing as waste.
Power tool, accessories and packaging should
be sorted for environment-friendly recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
English
30