Table 3- 1 Color Codes; Figure 3-1 Input Power Connector (P8) Wiring - Siemens SITRANS F Series Quick Start Manual

Commissioning
3.1 Connecting Power
Terminal Number
1
2
3
6. Plug input power connector P8 into connector J8 and secure using two captive connector
7. Secure power input cable with cable clamp to prevent wire breakage.
8. Replace Rear Housing Cover and tighten setscrew.
9. Connect the power cables to the appropriate power source previously selected from the
Note
Loosen Wire Clamp Screw, insert stripped end of wire and then retighten.
Table 3- 1
USA
EU
18
1010X-6SS2
Hot
Neutral
Ground
mounting screws as indicated below.
tables above and power up unit (100-250 VAC @ 50/60 Hz or 9-36 VDC).
① Wire Clamp Screws
② Connector Mounting Screws
③ Stripped Wire
Figure 3-1 Input Power Connector (P8) Wiring
Color Codes
HOT
BK
BR
1010X-6ZNS2
Positive
Negative (Gnd)
Ground
NEU GND
WH GRN
BL Y/GRN
Operating Instructions (Compact), 1/2009, CQO:QSG005 Revision B
1010X-6ZPS2
Positive
Negative (Gnd)
Ground
SITRANS FUG1010 Quick Start