Figure 3-6 Transducer; Figure 3-7 Transducer Installation - Siemens SITRANS F Series Quick Start Manual

11. Slide transducer into a Mounting Frames back end first aligning the angled edge of the
12. Tighten the transducer Clamping Screw to hold the transducer in place.
①
②
③
④
⑤
Figure 3-7
SITRANS FUG1010 Quick Start
Operating Instructions (Compact), 1/2009, CQO:QSG005 Revision B
① Coupling Compound
② Emitting Surface
③ Back End
Figure 3-6 Transducer
transducer with the angled edge of the Mounting Frame. Keep transducer from making
contact with the pipe until it butts up against the Mounting Frame stop.
installation procedure for the other transducer
Front View
Spring Clip (Not present on some models)
Transducer Clamping Screw
Spacer Bar
1012 Series Mounting Frame
Transducer Installation
3.5 Transducer Installation
④ Transducer
⑤ Angled Edge
⑥ F-Connector
.
⑥ Mounting Strap
⑦ Note: Operational 2nd Mounting Strap
shown. Larger pipes may need an
additional strap for a more secure mount.
⑧ Spacer Bar Platform and Clamping Screw
⑨ Spacer Bar Reference Hole
⑩ Orientation for Single Beam Transducer at
9 o'clock position
⑪ Orientation for Dual Beam Transducer at
10 & 2 o'clock positions
Commissioning
Repeat
31