Table of Contents
Advertisement
Figure 30 Install the transceiver module
Remove the dust cap from the transceiver module and the protective caps from the fibers.
3.
Plug the LC connectors on one end of the fiber cable into the Rx and Tx ports, and plug the LC
4.
connectors on the other end to the Tx and Rx ports on the peer device, as shown in
Figure 31 Connect the fiber connectors
After the firewall is powered on, and the LEDs of the optical interfaces are steady on, the
5.
connection is normal. For more information about the LED status, see the chapter
LEDs."
IMPORTANT:
For more information about the optical fibers, see the chapter
Note the following guidelines:
"Appendix C
28
Figure
31.
"Appendix B
Cables."
Advertisement
Table of Contents
