Connecting An Optical Fiber - HP F5000 Installation Manual

After the firewall is powered on, check the status LED of the Ethernet ports. If the LED is solid green,
2.
the connection is normal. For more information about the LED status, see the chapter
LEDs."
NOTE:
For more information about Ethernet twisted pair cables, see the chapter

Connecting an optical fiber

Before connecting the firewall to the network, you must install a transceiver module to the firewall, and
then insert the fiber connector to the transceiver module. The A–F5000 supports LC connectors only.
Follow these steps to connect optical fibers:
Remove the dust plug from a fiber port of the firewall.
1.
Figure 29 Remove the dust plug
Install the transceiver module, as shown in
2.
Figure 30.
27
"Appendix B
"Appendix C Cables."