Figure 21 Push the fan tray into the slot
Use a Phillips screwdriver to fasten the captive screws on the fan tray.
2.
After the firewall is powered on, the RUN LED of the fan tray is steady on. This means that the fan
3.
tray runs properly. For the LED description of the fan tray, see the chapter
Installing a CF card
Follow these steps to install a CF card:
Push the CF card eject button all the way into the slot, and make sure that the button does not
1.
project from the panel.
Insert the CF card into the slot following the direction shown in
2.
not project from the slot.
22
"Appendix B
Figure
22, and make sure it does
LEDs."