Table of Contents
Advertisement
10.2 Mounting
1. Lay the decaled image face down on a flat surface. Carefully
peel back and put a crease along the edge of the release
liner (Approximately 1 inch or 25mm, Figure 1).
2. With the image facing up, align the image onto the board.
Press firmly from the center out (Figure 2).
3. Adjust the pressure lever to ensure the proper opening
(Figure 3).
4. Flip the image over the upper roller and hold on to the release
liner (Figure 4).
5. Press the foot pedal once, and then let it go while slowly
pulling the release liner as the board enters the main roller
nip (Figure 5).
Press the foot pedal once again when the board has
completely exited from the rear of the unit.
Trim the board if necessary.
RSC-1401CLTW /RSC-1651CLTW /RSC-1653P
11
11
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Advertisement
Table of Contents
