Ayre QX-5 Owner's Manual page 45

Update Error
If the display shows UPDATE ERROR there
was an error during the network update process
(Update interrupted by power failure or network
failure). Restart the unit.
If the network module is no longer responsive,
then the update failure caused the module to fail
and it will need to be replaced. Contact the Ayre
dealer for service.
Network
If the QX-5 Twenty cannot be seen as a device on
your home network follow this proceedure.
If you're using an Ethernet cable, turn the unit
off. Verify that the Ethernet cable is attached to
the Ethernet port on the rear panel of the unit,
and that the cable is connected to a router on the
network. Turn the QX-5 Twenty back on. Ensure
the NET input is enabled (not set to OFF) in
the setup menu. If the problem persists, restart
your router. If it is not solved by restarting your
router, contact the Ayre dealer.
If you're using Wi-Fi, follow the steps in the
manual for connecting wirelessly and ensure
that the unit is connected to your local wireless
network. If these steps are followed and the unit
still cannot be seen, restart the QX-5 Twenty. If
44