Table of Contents
Advertisement
22
2) Insert the included Wi-Fi antenna into one of
the USB Host connector.
Ensure NO Ethernet cable is
connected.
3) Turn on the QX-5 Twenty via the rocker switch
on the rear panel.
4) Enter the Setup Menu by holding down
the left-hand button until MAIN INPUT is
displayed.
5) Scroll to MAIN NET by using the right- or
left-arrows on the control ring on the right-hand
side of the faceplate.
6) Press the right-hand button.
7) Using the right or left arrow on the control
ring, scroll to NET WPS. Press the right-hand
button. The front panel display will now read
WPS START.
8) Press the right-hand button. WPS mode will
now be engaged. The unit will be in this mode
until it connects to your router, or until you exit
this menu by pressing the left-hand button once.
9) At this point you will need to press the WPS
button on the back of your home network router,
or follow its instructions to initiate WPS, or Wi-Fi
Protected Setup mode.
Advertisement
Table of Contents
