Table of Contents
Advertisement
10) Once the wireless link has been created,
the display of the QX-5 Twenty will read
CONNECTED. The display will then revert to
NET WPS.
11) Now press the left-hand button until you've
exited the Setup Menu, or until you reach the
next item you would like to configure.
Wire-Aided Wi-Fi Connection
These instructions allow
This connection method requires that you
you to connect to a password
temporarily use an Ethernet cable to authenticate
protected, non-WPS enabled,
communication between your QX-5 Twenty
wireless router.
and your home network. Afterwards you may
disconnect the cable and place the QX-5 Twenty
in its permanent location.
Before beginning, please download the mconnect
control app, see Apps (pg. 31).
1) Turn off the QX-5 Twenty via the rocker switch
on the rear panel.
2) Make sure the Ethernet cable for your network
is connected to the port in the back of the unit.
3) Insert the included Wi-Fi antenna into one of
the USB Host connectors.
4) Turn on the QX-5 Twenty via the rocker switch
on the rear panel.
23
Advertisement
Table of Contents
