Ayre QX-5 Owner's Manual page 22

12) Go to Settings ( symbol left hand corner).
13) Select "Device Setup" from the menu.
14) Select "Ayre QX-5" from the device list.
15) Select "Wi-Fi network selection."
16) Find your home network on the list.
17) If your home network requires a password,
enter it at this time.
18) The QX-5 Twenty will automatically join
your home network. Once the connection
to the network is made, the display will read
CONNECTED. (This may take 10 - 15 seconds)
19) The display will then revert to NET AP.
20) Now press the left-hand button until you've
exited the Setup Menu, or until you reach the
next item you would like to configure.
WPS Mode
Not every router or modem is
WPS (Wi-Fi Protected Setup) allows you to
capable of WPS mode, please
easily connect your QX-5 Twenty to your home
check your router's manual for
network, without the use of an Ethernet cable.
this feature.
1) Turn the QX-5 Twenty off via the rocker switch
on the rear panel.
21