Overhaul - Gage Bilt GB704SH-5 Series Original Instructions Manual

WARNING:
Only qualified and trained personnel shall perform overhaul.
WARNING:
Personnel must read and understand all warnings and cautions.
WARNING:
Tool must be maintained in a safe working condition at all times and examined on a daily basis for damage or
wear. Any repair must be done by qualified personnel trained on Gage Bilt procedures.
WARNING:
Disconnect tool from its power source before performing overhaul. Severe personal injury may occur if power
source is not disconnected.
WARNING:
Excessive contact with hydraulic oil and lubricants must be avoided (See safety data sheet documents for all
applicable materials
WARNING:
When operating, repairing or overhauling tool, wear approved eye protection. Do not look in front of tool or
rear of tool when installing fastener.
WARNING:
Use only Gage Bilt hydraulic hoses and couplings, or equivalent, rated for 5,000 psi. (344.8 bar) working pressure.
WARNING:
Ensure air hose is securely connected to avoid possible hose whipping (Air Actuated Tools only).
WARNING:
Depress lever (704345) and disconnect from air, with the piston in the rear position, before overhaul. Severe
personal injury may occur if air hose is not disconnected.
with head cylinder removed. Hydraulic oil will eject forcibly from handle assembly.
Note:
•
Dispose of hydraulic oil in accordance with manufacture safety datasheet.
•
All tool materials are recyclable except rubber o'rings, seals and wipers.
•
It is recommended that service tool kit (GB740SHTK) (see below) be used to facilitate overhaul.
•
Use of SERVICE KIT (704040), which contains a complete set of o'rings, back-up rings, screws, washers and gasket, can
achieve a complete overhaul.
Perform overhaul in a clean, well lit area using care not to scratch or nick any smooth surface that comes in contact with an o'ring. Use
of Lubriplate® (Gage Bilt part no. 402723) or other lubricant is recommended during reassembly to prevent tearing or distorting of o'rings.
The disassembly and re-assembly procedure can be accomplished by utilizing the instructions and parts lists on pgs. 14-18. Use extreme care
during disassembly and re-assembly not to mar or nick any smooth surface that comes in contact with seals. Before installing seals, always
apply a good lubricant, such as Lubriplate, to the surfaces.
Clean parts in mineral spirits or other o'ring compatible solvent being sure to clean o'ring grooves. Inspect components for scoring,
excessive wear or damage.
1. When tool life is met, drain hydraulic oil from tool and dispose of the hydraulic oil in accordance with the safety datasheet.
2. Disassemble tool and remove all rubber o'rings, seals, wipers and hydraulic hoses. All tool materials are recyclable except rubber
o'rings, seals, wipers and hydraulic hoses. Dispose of rubber materials in accordance with the material safety datasheet.
GB704SH-5 PNEUDRAULIC INSTALLATION TOOL..

OVERHAUL

).
GB740SHTK Service Tool Kit Includes:
Part No. Description
704149 Piston Rod Wrench Assembly
704151 Power Cylinder Tool Assembly
704150 Packing Plug Wrench Assembly
704152 Seal Guide
704153 Air Bleeder Assembly
744251 Valve Spring Installation Tool
744152 Valve Sleeve Removal Tool
S1178 Valve Extractor
745263 Fill Bottle (Large)
204330 Seal Guide
731163 Bleeder Bottle
TOOL DISPOSAL
14
USE CAUTION when forcing piston rod assembly downward
12/21 REV 4/22