Table of Contents
Advertisement
WARNING:
Do not cycle tool without air bleeder assembly (704153), or the screw and stat-o-seal, installed in tool head. Severe
personal injury could result.
WARNING:
Use CAUTION when removing screws, air bleeder assembly (704153) and fill bottle (745263). Hydraulic oil may be under
pressure.
CAUTION:
Before filling handle assembly (744129), air piston assembly (744121) must be all the way down.
CAUTION:
When forcing piston rod assembly (744136) downward, with head cylinder assembly (704182) removed, hydraulic oil will
eject forcibly from handle assembly (744129).
CAUTION:
When bleeding tool, ensure tubing is free from kinks or other obstructions.
Note:
•
Air Bleeder Assembly (704153) (sold separately) is required.
* FILLING & BLEEDING VIDEO AVAILABLE AT: http://www.gagebilt.com/rivet_tools_videos.php
1.
Ensure set screw and lever on handle assembly (700343) has been removed.
and head cylinder assembly (704182) upward and lay flat on a table or bench. When bleeding tool always keep the head cylinder
assembly (704182) higher than the handle assembly (744129).
2.
Remove button head cap screw (402482) and stat-o-seal (S572) from manifold-handle (744303) hole marked #3. Attach air bleeder
assembly (704153) (sold separately) to manifold-handle (744303) hole marked #3 in an upright position.
3.
Connect the tool to air supply and cycle tool ten times holding the poppet valve (A-648) down for 2-3 seconds between
cycles to remove any air from the tool.
4.
Disconnect air supply. Remove air bleeder assembly (704153) from manifold-handle (744303) and replace with button head cap
screw (402482) and stat-o-seal (S572) and torque to 35-40 inch lbs. (3.95 - 4.52 Nm). Do not over tighten.
5.
Remove button head cap screw (402482) and stat-o-seal (S572) from bleeder hole on head cylinder assembly (704182) and attach
air bleeder assembly (704153) in an upright position.
6.
Connect air supply. Cycle tool ten times removing any air bubbles.
7.
Disconnect air supply. Remove air bleeder assembly (704153) and replace button head cap screw (402482) and stat-o-seal (S572)
and torque to 35-40 inch lbs. (3.95 - 4.52 Nm). Do not over tighten.
8.
Connect air supply. Cycle tool ten times and check stroke of .600" (15.24 mm) using instructions a thru c and diagram below. We recommend
using dial calipers.
a. With the poppet valve (A-648) released, check dimension (A).
b. Holding poppet valve (A-648) check dimension (B).
c. Subtract dimension (B) from dimension (A). If stroke is not consistent within 1/64" (.396 mm) repeat bleeding procedure
until stroke met.
For your consideration, Gage Bilt offers a depth gage (Pt.# A-1935) to help simplify and more accurately check your tool stroke.
Please contact Gage Bilt for more information.
9.
Disconnect air supply.
10. Re-attach lever and set screw to handle assembly (700343).
GB704SH-5 PNEUDRAULIC INSTALLATION TOOL..
BLEEDING PROCEDURE:
Images may not reflect actual tool.
12
Stand handle assembly (744129) on floor, stretch hose
Hole marked #3 on
Manifold Handle (744303)
Air Bleeder
Assembly
(704153)
12/21 REV 4/22
Advertisement
Table of Contents
