Textron Jacobsen HR800 Instruction Sheet

This kit is intended for use on HR800 mowers.
! CAUTION
Before you install this kit, read the mower's manual to
become familiar with the vehicle, the controls, and
proper use of the equipment.
Stay alert for potential hazards and follow all safety
precautions. Read all instructions completely and
make sure you understand them before proceeding
with the assembly.
1. Park the mower on a flat and level surface, lower cutting
units to the ground, disengage all drives, engage the
parking brake, turn the ignition switch to the OFF
position, and remove the key.
Preparation ______________________________________________________________________
1. Start the engine and lift the front deck off the ground.
Stop the engine and remove the key.
Wing Decks ______________________________________________________________________
NOTE: Right wing deck assembly shown. Left wing deck
assembly similar.
1. Remove hardware (A) from the four locations shown.
The hardware will be reused with the mulching baffles.
2. Position the right wing deck mulching weldment (Item 1)
under the right wing deck. Loosely assemble hardware
(A).
3. Adjust the position of the mulching weldment as required
to obtain equal clearance for full rotation of the blades.
Securely tighten hardware (A).
4. Repeat for left wing deck using left wing deck mulching
weldment (Item 2).
Litho in U.S.A. 7-2017 © 2017 Jacobsen, A Textron Company/Textron Innovations Inc.
INSTRUCTION SHEET
HR800 Mulching Kit 4382306
a. Wait for all movement to stop before making any
adjustments or modifications.
b. Allow sufficient time for the unit to cool down.
c. Take this opportunity to thoroughly inspect the
equipment and perform other required maintenance.
! WARNING
Before you attempt to clean, adjust, or repair any of
this equipment, lower cutting units to the ground,
disengage all drives, shut down the mower, and allow
the unit to cool. Remove the key from the ignition
switch and disconnect the power connector to prevent
accidental discharge and potential bodily injuries.
2. Place supports under the four corners of the front deck.
Lower the deck onto the supports.
3. Repeat for left and right wing decks.
A
A
A
A
1 / 2
A A
Part No. 4396353-Rev A
A
A
Figure 1