Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ronix 6402
Summary of Contents for Ronix 6402
- Page 1 ELECTRIC SANDER 6402...
-
Page 2: Specifications
SPECIFICATIONS Model 6402 Power 220W Voltage 220V Frequency 50Hz No Load Speed 15000rpm Sanding Surface Size 101×100mm Net. Weight 1.4Kg Accessories Sponge pad PARTS LIST Upper Housing Screw ON/ OFF Switch Cable Arbor Clamp Sanding Pad USER MANUAL... -
Page 3: General Safety Rules
WARNING! Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock, fire and or serious personal injury. NOTE: SAVE THESE INSTRUCTIONS GENERAL SAFETY RULES WORK AREA - Keep work area clean and well lit. Cluttered and dark areas invite accidents. -
Page 4: Personal Safety
of electric shock. - If operating a power tools in a damp location is unavoidable, use a residual current device (RCD) protected supply. Use of an RCD reduces the risk of electric shock. PERSONAL SAFETY - Stay alert, watch what you are doing and use common sense when operating a power tool. - Page 5 - Do not (use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. - Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools.
-
Page 6: Functional Description
- Always use safety glasses or goggles, protective hat or mask, Ordinary eye or sun glasses are NOT safety glasses. - Do not leave the tool running. Operate the tool only when hand-held. - Hold tool by insulated gripping surfaces when performing and operation where the cutting tool may contact hidden wiring or its own cord. - Page 7 INSTALLING OR REMOVING THE ABRASIVE PAPER To install the abrasive paper, operate the clamp lever to open the paper clamp. Insert the paper end into the clamp. Center the paper and align the edges parallel to the pad, then lower the clamp lever to secure the paper.
-
Page 8: Replacing Carbon Brushes
Take away the old brush, put on the new carbon brush and brush holder, fix on the carbon brush line and the stator line together. 2) Both carbon brushes should be replaced at the same time. Use only standard brushes provided by RONIX SERVICE. USER MANUAL... - Page 9 10 minutes. Then check the tool while running, when pushing the switch button. NOTE: To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by RONIX SERVICE Authorized centers, always using RONIX replacement parts. ELECTRIC SANDER...
Need help?
Do you have a question about the 6402 and is the answer not in the manual?
Questions and answers