Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ronix 6122
Summary of Contents for Ronix 6122
- Page 1 ELECTRIC POLISHER 6122...
-
Page 2: Specifications
SPECIFICATIONS Model 6122 Rated Voltage 220V Frequency 50HZ Input Power 1200W No Load speed 1600-4500r/min Disc Capacity 150mm Net weight 2.85KG hex wrench 1pc carbon brush 2pcs polish disk 1pc Accessories manual 1pc side handle 1pc round foam 1pc PARTS LIST... -
Page 3: General Safety Rules
GENERAL SAFETY RULES WARNING! Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock. Fire and/ or serious personal injury. SAVE THESE INSTRUCTIONS WORKS AREA - Keep your work area clean and well it. Cluttered benches and dark areas invite accidents. -
Page 4: Personal Safety
marked ‘W-A” or “W”. These cord are rated for outdoor use and reduce the risk of electric shock. PERSONAL SAFETY - Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use tool while tired or medication. A moment of inattention while operating power tools may result in serious personal injury. - Page 5 - Disconnect the plug from the power source before making any adjustments. Changing accessories. Or storing the tool. Such preventive safety measures reduce the risk of starting the tool accidentally. - Store idle tools out of reach of children and other untrained persons. Tools are dangerous in the hands of untrained users.
- Page 6 operation. Replace cracked, damaged or deformed pad immediately. - Hold tool by insulated gripping surfaces when performing and operation where the cutting tool may contact hidden wiring or its own cord. Contact with a “live” wire will make exposed metal parts of the tool “live” and shock the operator.
- Page 7 SYMBOLS The following show the symbols used for the tool. voltage no load speed. ampere --/ min revolutions or reciprocation per minute hertz CLASS II CONSTRUCTION INSTALLING OR REMOVING WOOL BONNET CAUTION: Always be sure that the tool is switched of and unplugged before installing or removing wool bonnet.
- Page 8 INSTALLING THE LOOP HANDLE Always install the loop handle on the tool before operation. Hold the tool’s switch handle and the loop firmly with both hands during operation. Install the loop handle so that its protrusion will fit into the matching hole in the tighten them with the hex wrench.
- Page 9 SPEED ADJUSTING DIAL 1) This tool is equipped with electronic adjusting switch. Usually be set on “1” position before starting. 2) The tool speed can be changed by turning the speed adjusting dial to a given number setting from 1 to 6.(At the time when the switch trigger is fully pushed.) 3) Higher speed is obtained when the dial is turned in the direction of number6.
-
Page 10: Replacing Carbon Brushes
If the tool is not working well, ask your local center for repair. Ronix service To maintain product SAFETY and RELIABLITY, repairs, and other maintenance or adjustment should be performed by Ronix Authorized or Factory service centers, always using Ronix replacement parts. USER MANUAL...