Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ronix 6404
Summary of Contents for Ronix 6404
- Page 1 ELECTRIC SANDER 6404...
-
Page 2: Specifications
SPECIFICATIONS Model 6404 Power 230W Voltage 220V Frequency 50Hz No Load Speed 13000RPM Sanding Surface Size 100×110mm Net. Weight 1.3Kg PARTS LIST Upper Housing Cable Arbor ON/ OFF Switch Clamp Sanding Pad WARNING! Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock, fire and or serious personal injury. -
Page 3: General Safety Rules
NOTE: SAVE THESE INSTRUCTIONS GENERAL SAFETY RULES WORK AREA - Keep work area clean and well lit. Cluttered and dark areas invite accidents. - Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. -
Page 4: Personal Safety
PERSONAL SAFETY - Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. - Page 5 preventive safety measures reduce the risk of starting the power tool accidentally. - Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users.
-
Page 6: Functional Description
with a «live» wire will make exposed metal parts of the tool «live» and shock the operator. - This tool has not been waterproofed, so do not use water on the workpiece surface. - Hold the tool firmly. - Ventilate your work area adequately. when you perform sanding operations. - Page 7 INSTALLING OR REMOVING THE ABRASIVE PAPER To install the abrasive paper, operate the clamp lever to open the paper clamp. Insert the paper end into the clamp. Center the paper and align the edges parallel to the pad, then lower the clamp lever to secure the paper.
-
Page 8: Replacing Carbon Brushes
3) User can make a general choice to sanding different material, for rough sanding the roughness abrasive paper should be chosen, in reverse you can get good surface. REPLACING CARBON BRUSHES NOTE: 1) Remove and check the carbon brushes regularly. Replace when the tool occurs obvious sparks or wear down to the limit mark.
Need help?
Do you have a question about the 6404 and is the answer not in the manual?
Questions and answers