Removing A Drive From The Drive Bay - HP xw4000 Hardware Reference Manual

Removing a Drive from the Drive Bay

Hardware Reference Guide
7. Connect the opposite end of the cables to the appropriate system
board connector.
8. Replace the computer access panel.
9. Reconfigure the computer, if necessary. See the section,
"Installation Sequence," for more information.
1. If you have locked the Smart Cover Lock, use Computer Setup to
unlock the lock.
2. Shut down the operating system properly, then turn off the
computer, disconnect the power cord from the power outlet, and
remove the computer access panel.
3. Remove the front bezel.
4. Disconnect the drive power and signal cables and, if it is a
CD-ROM or DVD-ROM drive, disconnect the audio connector.
Hardware Upgrades
2–21