Advertisement
2.6. Grasp spring near onje end with needle-
nose pliers. Insert spring one end fi rst then
compress to complete installation. Lightly
tighten the front and rear hex screws.
2-8. Re-install the Dampers in their original
positions and ensure that they are prop-
erly seated. Re-install the Damper Holder
Bracket, the Head Cover Bracket and the
Height Adjustment Lever.
2-12. Perform an Ink Fill Up to fi ll the new
Heads with ink (MAINTENANCE
UP INK). As the printer is in Service Mode
you can choose just Pump 1 or Pump 2 if
desired.
© 2005 Mimaki USA
2-7a. Thread Head FPC Cables back
through the Damper Holder. Cable HCN2
goes through the left slot and HCN1 through
the right. Blue side of cables face to the left.
2-10. Restore power to the printer and put
into Service Mode. (FUNCTION and RE-
MOTE keys are held as printer boots).
2-13. Perform a TEST DRAW to confi rm
that all nozzles are fi ring correctly. Perform
FILL
additional Ink Fill Ups or Cleanings if nec-
cessary.
2-7b. Connect the FPC cables, taking care
that they are seated correctly. A cable seat-
ed at and angle may short out, damaging
cable and head! Lower Damper Holder into
position.
2-11. Use the arrow keys to enter the new
Head ID. (#ADJUST
HEAD ID). Ensure
that the correct Head is selected and all ID
values are entered correctly. Incorrect entry
will result in a error code.
Pg. 4/7
Advertisement
