Startup Sequence - Cisco 7936 Phone Manual

Connect the power supply unit to the AC adapter port on the PIM, and plug the other end
Step 4
into a standard electrical power outlet in the wall.
If you are using the External Microphone Kit, connect each of the microphone extensions to
Step 5
the microphone jacks installed on the bottom of the
Cisco Unified IP Conference Station 7936. See Figure 2 for an illustration of this connection.
Tip If you do not correctly connect the cables, PIM, power supply, and the microphone extensions,
the IP Conference Station will not work.
Use of non-Cisco-certified components may not work and may void the IP Conference Station
product warranty.

Startup Sequence

During the startup sequence, the LCD screen display shows the following messages.
Sequence Step
Startup—The startup process occurs about
15 seconds after power up.
Configuring IP address—These messages appear
when the protocol is configuring the IP address.
TFTP configuration—This message appears when
connectivity is established with the TFTP server.
Cisco Unified CallManager configuration—This
message appears when connectivity is established
with the Cisco Unified CallManager.
Cisco Unified CallManager registration—This
message appears while the device is registering
with the Cisco Unified CallManager.
Initialization complete.
14
LCD Screen Message Display
Cisco Systems, Inc.
Polycom Technology
Copyright 2003
Configuring IP
Press Menu to Reconfigure
Station IP: IP address
Contacting: TFTP Server
Opening: Cisco CallManager IP address
Registering
Press the Phone Key to get a dial tone