Removing The Front Bezel - HP Visualize J280 Supplementary Manual

Removing the Front Bezel

To remove the front bezel follow these steps:
CAUTION: Do not attempt to operate the workstation with the
1.
Attach the static–grounding wrist strap by following the instructions on the
package. Attach the the sticky end of the wrist strap to bare metal on the
system unit.
2.
Release the front bezel by pushing in the two locking tabs at the front of the
system unit as shown in Figure 1.
3.
Swing the panel down and pull up slightly so the two guide pins on the bottom
clear their guides and lay the front bezel down.
front bezel removed. The bezel is needed to ensure
proper air flow for system cooling.
Figure 1. Removing the Front Bezel
6