Table of Contents
Advertisement
USE
Making a tie
Hold the end of the branch and the
1
trellising wire firmly in your free
hand and bring the A3MV2 closer.
Position the tying head just before
the last node on the branch.
Firmly place the branch + the
2
trellising wire inside the tying
head.
Go right up to the abutment to ensure
that the arm closes fully and attaches the
wire correctly.
Move the machine back firmly to
3
release the tying head: the wire
then wraps round the branch. Press
control switch to complete the tie.
The knot is made more or less tight
depending on how far you pull back the
machine (see next chapter).
The tie holds the branch on the
4
trellising wire.
11
Advertisement
Table of Contents
