HP Vectra VL420 Upgrade Manual page 29

Hp vectra vl420: supplementary guide

Hide thumbs Also See for Vectra VL420:

Table of Contents

4 Remove the two side rails from the vacant space in the drive tray and screw them to the new hard

drive. Use the internal sticker on the base of the PC to locate the four screws (see picture in step 3).

5 Slide in the new hard drive into position and fasten the two retaining clips to secure the drive.

6 Attach the data and power connectors. Assuming you want to use the original hard drive to boot your

PC from, attach the end connector (marked DRIVE 0) to this drive and the middle connector (marked

DRIVE 1) to the new drive.

7 Replace the PC's cover. Refer to page 13.

8 Verify the new configuration by checking the HP Summary screen. To access the HP Summary Screen,

press F8 then Esc when the HP logo appears during startup

Note

Ensure that you have installed all the required operating system and HP drivers on the newly installed drive. To reinstall operating

system and HP drivers, use the Recovery CD-ROMs provided with the PC. In addition, you can find the most up-to-date versions of HP

drivers on HP's Web site at:

www.hp.com/go/support

Upgrading and replacing hardware

Table of Contents