ZyXEL Communications NWA90AX User Manual page 80

Figure 55 Configuration > Wireless > AP Management > Setup Wireless Bridge Vlan ID: Wireless Bridge
Vlan Setting (NWA55AXE)
Each field is described in the following table.
Table 28 Configuration > Wireless > AP Management
LABEL DESCRIPTION
Radio 1 Setting
Radio 1 Activate Select the check box to enable the Zyxel Device's first (default) radio.
Radio 1 OP Mode Select the operating mode for radio 1.
AP Mode means the radio can receive connections from wireless clients and pass their data
traffic through to the Zyxel Device to be managed (or subsequently passed on to an
upstream gateway for managing).
Root AP means the radio acts as an AP and also supports the wireless connections with
other APs (in repeater mode) to form a WDS (Wireless Distribution System) to extend its
wireless network.
Repeater means the radio can establish a wireless connection with other APs (in either root
AP or repeater mode) to form a WDS.
Radio 1 Profile Select the radio profile the radio uses.
Note: You can only apply a 2.4G AP radio profile to radio 1. Otherwise, the first
Radio 1 WDS Profile This field is available only when the radio is in Root AP or Repeater mode.
Select the WDS profile the radio uses to connect to a root AP or repeater.
Enable WDS Wireless If you set the Zyxel Device as a root AP, the radio that's bridging with the Zyxel Device
Bridging should be in repeater mode.
Be careful to avoid bridge loops. For example, if your root AP and the Zyxel Device are
connected to a switch, and they're also connected to each other using a WiFi connection.
This will create bridge loops.
This field is available only when the radio is in Repeater mode. Select this to enable WDS
wireless bridging on the Zyxel Device. See
Wireless Distribution System (WDS).
NWA50AX/NWA90AX/NWA55AXE Series User's Guide
Chapter 10 Wireless
radio will not be working.
80
Section 1.2 on page 12 for more information on