Example Of Firmware Upload Using Ftp - ZyXEL Communications NWA90AX User Manual

Figure 118 Maintenance > File Manager > Firmware Package
The following table describes the labels in this screen.
Table 74 Maintenance > File Manager > Firmware Package
LABEL
Boot Module
Current Version
Released Date
File Path
Browse...
Upload
After you see the Firmware Upload in Process screen, wait two minutes before logging into the Zyxel
Device again.
Note: The Zyxel Device automatically reboots after a successful upload.
The Zyxel Device automatically restarts causing a temporary network disconnect. In some operating
systems, you may see the following icon on your desktop.
Figure 119 Network Temporarily Disconnected
After five minutes, log in again and check your new firmware version in the Dashboard screen.

17.3.1 Example of Firmware Upload Using FTP

This procedure requires the Zyxel Device's firmware. Download the firmware package from
www.zyxel.com and unzip it. The firmware file uses a .bin extension, for example, "600ABFH0C0.bin". Do
the following after you have obtained the firmware file.
Connect your computer to the Zyxel Device.
1
The FTP server IP address of the Zyxel Device in standalone mode is 192.168.1.2, so set your computer to
2
use a static IP address from 192.168.1.3 ~192.168.1.254.
Chapter 17 File Manager
DESCRIPTION
This is the version of the boot module that is currently on the Zyxel Device.
This is the firmware version and the date created.
This is the date that the version of the firmware was created.
Type in the location of the file you want to upload in this field or click Browse... to find it.
Click Browse... to find the .bin file you want to upload. Remember that you must decompress
compressed (.zip) files before you can upload them.
Click Upload to begin the upload process. This process may take up to two minutes.
NWA50AX/NWA90AX/NWA55AXE Series User's Guide
184