2
STS SUPPLY
As soon as a source is connected, the STS / ITS will turn on automatically. The LCD will turn on
as shown in the left figure and the LEDs will light up.
After the start-up, the display is as shown in the right figure, and the LEDs for Sources A and B
light up.
SWITCH BETWEEN SOURCE A SOURCE B
2.1
The STS / ITS supports manual control for switching between source A source B.
Press the button
The system requires confirmation of the switching of the supply (LCD will show on the LCD as
shown in Figure 1), to confirm, press the button again
will display the new source that powers the output (Figure 2). If the output is not available, the
display will display an alarm and the switch of supply will not occur.
STS / ITS 16/32A user manual
Utilizzo dell'STS / ITS 16/32A
for 2 seconds until you hear 2 consecutive
Figure 1
Figure 2
"
"
beeps
.
for 2 seconds, the LCD display
Figure 3
OMP06033 REV. B
5