General Characteristics; Special Features - Borri STS 16A User Manual

1

GENERAL CHARACTERISTICS.

The system called STS (Static Transfer Switch) has two independent input sources, Source A
(LINE 1) and Source B (LINE 2). Outputs are connected to the loads which, in normal operation,
are powered by the supply source A
If the source A voltage is missing or is out of range, the system automatically switches the loads
to source B.
If required, it is possible to configure one of the two lines A or B as a priority, through the
configuration software that must to be required to the Service department.
In this case, when the priority line A or B is reset, the load is automatically transferred to the
selected line.
LINE 1
LINE 2
1.1

SPECIAL FEATURES

1. Our high frequency power drive technology allows for greater integration of the SPS,
enabling it to be used even in enclosed environments.
2. The totally digital control system (DSP) of the SPS allows you to enhance the
functionality and high level of protection of the machine itself. The powerful
communication port enhances the remote control and supervision of the SPS.
3. The large input voltage tolerance (110-300 Vac) allows the use of the SPS in critical
power situations.
4. The integration of the STS with the ITS allows, in case of anomalies, a rapid
replacement of the device without interruption.
5. The STS is designed to comply with the various international standards on
electromagnetic interference compatibility (EMC).
4 OMP06033 REV. B
STS / ITS 16/32A user manual
Utilizzo dell'STS / ITS 16/32A
Input
Input
Output
load
LOAD