Installation - Borri STS 16A User Manual

2.3.4 Installation

The product must be installed in strict compliance with the instructions contained in the
technical back-up documentation, including the present safety instructions. In particular, the
following points must be taken into account:
 The product must be placed on a base suitable to carry its weight and to ensure its
vertical position;
 Never install the equipment near liquids or in an excessively damp environment;
 Never let a liquid or foreign body penetrate inside the device;
 Never block the ventilation grates;
 Never expose the device to direct sunlight or place it near a source of heat.
Special environmental conditions
The STS / ITS is designed for normal climatic and environmental operating conditions
as defined in the technical specification: altitude, ambient operating temperature,
relative humidity and environmental transport and storage conditions. It is necessary
to implement specific protective measures in case of unusual conditions:
 harmful smoke, dust, abrasive dust;
 humidity, vapour, salt air, bad weather or dripping;
 explosive dust and gas mixture;
 extreme temperature variations;
 bad ventilation;
 conductive or radiant heat from other sources;
 strong electromagnetic fields;
 radioactive levels higher than those of the natural environment;
 fungus, insects, vermin.
Use authorized personnel only
All transport, installation and start-up operations must be carried out by qualified and
trained personnel.
The installation of the STS / ITS must be carried out by authorized personnel, in
compliance with national and local regulations.
Do not modify the device
Do not modify the device in any way: this may result in damage to the equipment
itself as well as to objects and persons. Maintenance and repair must be carried out
by authorized personnel only. Contact the manufacturer for details of the nearest
service centre.
10 OMP068032 REV. B
Installation and start-up of STS / ITS 16/32A
Installazione e avviamento STS / ITS 16/32A