Electrical Connection; Operation; Maintenance - Borri STS 16A User Manual

2.3.5 Electrical connection

The STS / ITS connection to the AC power must be carried out in compliance with the current
regulations.
Make sure the indications specified on the identification plate correspond to the AC power
system and to the actual electrical consumption of all of the equipment connected.
Check the conformity to the Standards
The STS / ITS must be installed in compliance with the standards in force in the
country of installation.
All the electrical connections must be carried out by authorized personnel. Before connecting
the device make sure that:
 the connection cable to the AC line is properly protected;
 the nominal voltages, the frequency are respected;
 no leakage current to earth is present.
The device is connected to the following voltage supplies:
 AC mains voltage (Supply Line 1; Supply Line 2)
Injury hazard due to electric shock!
If primary power isolators are installed in an area other than the STS / ITS one, you
must stick the following warning label on the STS / ITS. "ISOLATE THE OUTPUT of
the STS / ITS BEFORE WORKING ON THIS CIRCUIT"

2.3.6 Operation

The installations to which the STS / ITS systems belong must comply with all the current safety
standards (technical equipment and accident-prevention regulations). The device can be
started, operated and disconnected only by authorized personnel.
The settings can only be changed using the original interface software.

2.3.7 Maintenance

Service and repairs must be carried out by skilled and authorized personnel. Before carrying out
any maintenance operation, the STS / ITS must be disconnected from AC supply sources.
Injury hazard due to electric shock!
Any operation must be carried out only when voltage is absent and in compliance
with safety directives.
 Isolate the device completely by operating the external circuit breakers.
High temperature of components
It is strongly recommended to use protective gloves due to the high temperatures that
may be reached during the operation.
Installation and start-up of STS / ITS 16/32A
Installazione e avviamento STS / ITS 16/32A
OMP68032 REV. B 11