Table of Contents
Advertisement
2
BACnet/LonWorks Setup through ProtoCarrier
2.1
Features
•
10/100BaseT Ethernet LAN interface (auto-sensing)
•
Multiple Protocol Support
•
Supports multiple configuration files and the ability to automatically load any of the stored files for different OEM
controllers or protocols supported.
•
ProtoCarrier- FPC-C34/C38
◦ FPC-C34: 2 RS-485 ports and 1 Ethernet port
◦ FPC-C38: 1 RS-485 port, 1 Ethernet port and 1 RS-232
•
ProtoCarrier- FPC-C35/C39
◦ FPC-C35: 1 Ethernet Port, 1 LonWorks port and 1 RS-485 port
◦ FPC-C39: 1 Ethernet Port, 1 LonWorks port and 1 RS-232 port
•
ProtoCarrier- FPC-C40
◦ FPC-C40: 1 RS-485 port, 1 Ethernet port and KNX port
•
ProtoCarrier- FPC-N42
◦ FPC-C42: 1 RS-485 port, 1 Ethernet port and M-Bus port
2.2
Installation Steps for the Customer
1. Record the information about the unit. (Section
2. Connect the ProtoCarrier to the field protocol port and customer's port to the ProtoCarrier's RS-485 interface.
(Section
3.4 Wiring Field Port to RS-485 BMS
3. Connect power to the ProtoCarrier.
4. Where the field protocol is BACnet/IP or Modbus TCP/IP, refer to Section
OEM Device
to run the Web GUI and change the IP Address.
5. Use a web browser to access the FieldServer Web Configurator page to select the profiles of the devices attached
to the FieldServer and enter any necessary device information. Once the devices are selected, the FieldServer
automatically builds and loads the appropriate configuration.
2.3
Record Identification Data
Each ProtoCarrier has a unique part number located on the side of the label. The number format is FPC-C34-XXXX. This
number should be recorded, as it may be required for technical support.
Part Number: __________________________________________________
6
2.3 Record Identification
Network)
ProtoCarrier Start-up Guide
Data)
3 Interfacing ProtoCarrier to Host
Advertisement
Table of Contents
Need help?
Do you have a question about the fieldserver ProtoCarrier and is the answer not in the manual?
Questions and answers