ADTRAN NetVanta 900 Series Quick Start Manual page 2

NetVanta 900 Series Ethernet Switch Access Module
Quick Start Guide
snmp trap link-status
Use the snmp trap link-status to control the SNMP variable ifLinkUpDownTrapEnable (RFC
2863) to enable (or disable) the interface to send SNMP traps when there is an interface status
change. Use the no form of this command to disable this trap.
speed {10 | 100 | auto*}
Use the speed command to configure the speed of an Ethernet interface. Use the no form of this
command to return to the default value.
10 10 Mb Ethernet
100 100 Mb Ethernet
auto Automatically detects 10 or 100 Mb Ethernet and negotiates
the duplex setting.
switchport access vlan <vlan id>
Use the switchport access vlan command to set the port to be a member of a VLAN. Use the no
version of this command to return to the default value (VLAN 1).
<vlan id>
switchport mode {access* | trunk}
Use the switchport mode command to configure the VLAN membership mode. To reset
membership mode to the default value, use the no version of this command.
access Sets port to be a single (non-trunked) port that transmits and
receives no tagged packets.
trunk Sets port to transmit and receive packets on all VLANs
included within its VLAN allowed list.
switchport trunk allowed vlan {add | all* | except | remove | <vlan list>} <vlan list>
Use the switchport trunk allowed vlan command to allow certain VLANs to transmit and receive
traffic on this port when the interface is in trunking mode. Use the no version of this command to
return to the default value. By default, all valid VLANs are allowed.
add Adds VLAN IDs to the VLAN trunking allowed list.
all Adds all VLAN IDs to the VLAN trunking allowed list.
except Adds all VLAN IDs to the VLAN trunking allowed list except
those in the command line VLAN ID list.
remove Removes VLAN IDs from the VLAN trunking allowed list.
<vlan list> Enter a list of valid VLAN interface IDs (1-510).
switchport trunk native vlan <vlan id>
Use the switchport trunk native vlan command to set the VLAN native to the interface when the
interface is in trunking mode. Use the no version of this command to reset the trunk native VLAN to
the default value. The default setting is VLAN 1.
<vlan id> Enter a valid VLAN interface ID (1-510).
* Indicates the default value.
Quick Start Guide, 61200793L1-13B, July 2004
Enter a valid VLAN interface ID (1-510).
Technical Support 1-888-4ADTRAN (1-888-423-8726)
P/N 1200793L1
Copyright © 2004 ADTRAN, All Rights Reserved