HP Kayak XU800 Installing And Replacing Hardware Manual page 9

NOTE
Removing the
Memory Expansion
Card
Removing, Replacing and Upgrading Memory on HP Kayak XM600 Models Shipped with SDRAM
5 To install a module, ensure that the two notches of the memory module
are aligned with those of the socket. With the two retaining clips open,
press the memory module completely into the socket. You hear two
clicks as the retaining clips click into position
6 Replace the HP UltraFlow Airflow Guide (refer to page 5 for
instructions).
7 Replace the PC Workstation's cover (refer to page 4). Reconnect all the
power and telecommunications cables.
8 Check the HP Summary Screen to verify the new configuration (refer to
"Viewing the HP Summary Screen" in the Section on "Setting Up and
Using Your PC Workstation")
Removing and Replacing the Memory Expansion Card
The unused memory sockets on the system board, RIMM0 and RIMM1
must contain a continuity module.
1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover (refer to page 3 for instructions).
3 Remove the HP UltraFlow Airflow Guide (refer to page 5).
4 For ease of installation, place the PC Workstation on its side with the
system board facing upwards.
5 To access the Memory Expansion Card, remove the retaining bar that is
in front of it.
Installing and Replacing Hardware Parts in Your PC Workstation
.
.
9