HP Kayak XU800 Installing And Replacing Hardware Manual page 4

Installing and Replacing Hardware Parts in Your PC Workstation
Removing and Replacing the Cover and Front Bezel
NOTE
Replacing the Cover
and Front Bezel
Take care when removing the upper and lower bezels. They are not on a
hinge, so do not force them open.
To remove the upper and lower bezels:
a Unclip the two clips located on the left-hand side of the bezel.
b Open the bezel slightly, and then gently push it outwards.
1 Ensure that all internal cables are properly connected and safely routed.
2 If necessary, replace the front bezel. To do this, ensure that the bezel is
correctly orientated, align the two plastic tabs with their slots on the
right-hand side of the chassis, and then close the bezel. If you have
removed both sections of the front bezel, first replace the lower bezel.
3 Standing at the back of the PC, lower the cover onto the chassis (aligning
the guide rail on the bottom inside edge of the cover with the bottom
edge of the PC chassis).
4 Shut the cover ensuring that the guides on the top of the cover slide into
the rails at the top of the chassis.
5 Slide the cover forwards, then tighten the two thumbscrews.
6 If required, lock the cover using the key provided. Reconnect all the
power and telecommunications cables.
4
a
a
b