HP Kayak XU800 Installing And Replacing Hardware Manual page 36

Installing and Replacing Hardware Parts in Your PC Workstation
Replacing the Rear Fan
Replacing the
Rear Fan
1 The rear fan can only be installed in one way. From the rear of the PC
Workstation, the two retaining clips should be positioned on the same
side as the chassis edge.
2 Connect the rear fan cable to its connector on the system board. Place
the cable between the power supply unit and processor.
3 Align the processor fan clips with their corresponding sockets.
4 Gently push the rear fan towards the rear panel connectors, until it clicks
into place.
5 Replace the HP UltraFlow Airflow Guide (refer to page 5).
6 Replace the PC Workstation's cover (refer to page 4). Reconnect all the
power and telecommunications cables.
36