HP Kayak XU800 Installing And Replacing Hardware Manual page 22

Installing and Replacing Hardware Parts in Your PC Workstation
Installing Mass Storage Devices
You should assign an unused SCSI ID to the second SCSI hard disk drive
(for example, SCSI ID 1).
The SCSI ID is usually configured with jumpers on the SCSI hard disk drive.
Refer to the installation guide supplied with the drive for information on
selecting a SCSI ID.
Some internal SCSI disk drives may have termination resistors that must be
removed or disabled before installation in your computer. Refer to the
drive's installation guide for more details and to see if there is a special
installation procedure to follow.
Power Connectors for HP Kayak XM600 and XU800 PCs
Additional Guide Rails
Attached on the side of the front access cage (inside the PC Workstation),
additional guide rails are available for mass storage device installations.
Depending on the device to be installed, dedicated guide rails are required
and are easily recognized by their distinct size and color.
The following table indicates the device, location, and required rails.
Device to be Installed
3.5-inch device (hard disk drive)
5.25-inch device (CD-ROM, etc.)
1
3.5-inch device (zip drive or
second floppy disk drive)
1. Some models, a third hard disk drive can be installed. Refer to page 26 for installation
instructions.
22
Power Cable for 3.5-inch Floppy
Disk Drive
Location
3.5-inch internal Short blue left and right rails
shelf (L or R indicated on the rail)
5.25-inch front Long green rails
access cage
Short green left and right rails
shelf
(L or R indicated on the rail)
Power Cables for Hard Disk Drives, Zip
Drives, Tape Drives, CD-RW,
CD-ROM Drives and DVD drives
Required Rails