WARNING
Installing HP FastRAID
To install the Adaptec
step-by-step instructions below.
1 Remove the computer's cover. Refer to the User's Guide that came
with your PC or PC Workstation, if necessary.
For your safety, never remove the computer's cover without first
removing the power cord and any connection to a telecommunications
network. Always replace the cover before switching on the computer.
2 Locate the RAIDport slot on the PC Workstation's system board.
Refer to the User's Guide that came with your PC or PC
Workstation, if necessary.
3 Unscrew and remove the slot cover. If the slot cover is hard to
remove, loosen the screws on the adjacent slots.
4 Hold the adapter board horizontally by its "top" edge. Slide it into the
board guide of the RAIDport socket. Do not bend the board.
5 Align the board's connector with the slot's socket. Firmly press the
board into the socket. Make sure that the board's connector is fully
seated in the socket and does not touch components on other
boards.
6 Secure the board by replacing the slot cover screw. If you loosened
the screws on adjacent slots, tighten them.
7 Replace the cover and connect all cables and power cords.
®
ARO-1130 accessory in your PC, follow the
Your PC, and the location
of its accessory board
slots, may be different to
the one shown here.
English
English 3