NOTE
Step 3: Removing/Reinstalling the Upper Processor Airflow
Guide
Removing the Upper Processor Airflow Guide:
Press the tabs inwards.
Lift the airflow guide
slightly.
Pull the airflow guide
up and then diagonally
out towards the front of
the chassis.
To Reinstall: Be sure to fit tabs so that they snap back into the recesses shown above.
Access to the floppy hard disk drive and the CD-ROM drive is now possible
(see "Step 5: Removing/Installing the CD-ROM and FDD" on page 8).
Step 4: Disconnecting/Reconnecting the HDD, FDD and
CD-ROM Cables
The HDD, FDD and CD-ROM
cables are located as shown:
Unplug the HDD and CD-
ROM cables (IDE1 and IDE2)
from the system board.
Step 3: Removing/Reinstalling the Upper Processor Airflow Guide
CD-ROM (IDE 1)
HDD (IDE 2)
FDD
7