Answers And Explanations - HP Kayak XA-s02 Supplementary Manual

Answers and Explanations

1 On a Kayak XA-s with standard 32 MB non-ECC memory, what hap-
pens when a 128 MB ECC non-buffered DIMM is added?
b It boots OK in non-ECC mode (refer to
2 When the SCSI controller is found to be defective on a
Kayak XA-s SCSI model, what should be removed to replace the faulty
SCSI controller?
d Cover, LAN+SCSI card (refer to
3 The LCD displays shows 'Error! No Proc'. What hardware must be
removed to check that the Pentium II is properly inserted?
c Cover, Upper Processor Airflow Guide, Lower Processor Airflow
Guide + Fan, Processor (refer to
4 When reassembling the PC Workstation after upgrading the
Pentium II processor, what are the critical step(s) to perform once the
Pentium II has been plugged into its socket with an audible click?
d Reconnect the processor fan and the VRM to the system board (refer
to page 9).
5 In the following list, tick all items that you MUST remove prior to replacing
the system board:
a power supply.
c video controller.
d Pentium II processor.
e mass storage device cables (refer to
6 In the flowing list, tick what you need to remove in order to have EASY
access to replace a DIMM in the 1st slot:
a power supply.
b floppy drive cable.
d hard disk cardcage (refer to
page 14).
page 5).
page 5).
page 5).
page 5).
Answers and Explanations
19